Featured
Popular Shows
Recent forum threads
- Johnson swivel hook removalI need to remove this hook, but I've never encountered an attachment like this. Does anyone know how it disconnects… Read more »
- RFQ - Magnesium forgings project approximately project 36"x3"x6" long.Please let me know if you have a domestic shop that can run about 500 units. This would be for… Read more »
- O/T - Solidworks "Sketch endpoints and center points cannot be deleted..."Trying to finish a simple 2D sketch by deleting the points to make one continuous part so I can (hopefully)… Read more »
- WTS: Kwik Switch 300 Tooling Lot $800 ShippedUsed Universal Engineering Kwik Switch 300, tool holders and collet sets. 17 holders and 33 collets and pictured tooling $800… Read more »
- How to deburr this? I dont know how to get at the inside edge. I have tried using the squiggly deburring tool but that does not do a very good job.This cut were made on a table saw. ( I know but it's how the boss wanted it done). Thank… Read more »
- Anyone know about servicing a Mindman MACP300L Air Unit?My Sharp SV-2412SX has a Mindman MACP300L Air Unit (pics attached). I'm not seeing any oil flow from the drip… Read more »
- Starrett goes privateTHE L.S. STARRETT COMPANY ENTERS INTO A MERGER AGREEMENT WITH MIDDLEGROUND CAPITAL TO BECOME PRIVATE COMPANY www.starrett.com animal Read more »
- What Supplier Nonsense are You Dealing With Today?It seems to be never ending here! Here's a sample of my most frustrating ones of the last couple of… Read more »
- Any idea where i can order to make a part?In this big and limitless world of metal, I wonder where I could order to have a bolt/stud manufactured like… Read more »
- Lifespan of China made motors in the shopMy Google fu is bad. All I find is how short a life china made cars have before they are… Read more »