hi,
I wanted to get two wheels for a little 6x12 norton manual surface grinder, one for putting a fine finish on soft steel and the same for hardened steel.
I was thinking of a Carborundum 32AR 60-I or H for the hardened steel and a 60-K for the soft. This is based on nothing more than the 60 seems to be recommended as a finer grit and to use a soft wheel for hard steel etc..... but i don't have a lot of experience in wheel picking so any guidance and recommendations for general purpose wheels is appreciated.
thanks
I wanted to get two wheels for a little 6x12 norton manual surface grinder, one for putting a fine finish on soft steel and the same for hardened steel.
I was thinking of a Carborundum 32AR 60-I or H for the hardened steel and a 60-K for the soft. This is based on nothing more than the 60 seems to be recommended as a finer grit and to use a soft wheel for hard steel etc..... but i don't have a lot of experience in wheel picking so any guidance and recommendations for general purpose wheels is appreciated.
thanks