graystoneltd
Plastic
- Joined
- Feb 2, 2004
- Location
- somewhere, MD
Atlas 12"x 36 (between Centers) lathe with quick change gear box for threading. This is one of the nicer used Atlas Lathes I have seen. The bed is not worn and the gears on the carriage are all nice and sharp. Comes with 5" 3-jaw, 8" 4-jaw, Face plate, Dead center, Steady rest, Parting tool holder, Tool holder, MT2-1/2" Drill chuck, 1 HP motor (reversible if extra switch added) stand. Power cross feed, back gearing for slow speeds, all the belt change mechanisms work AOK. All carriage mechanicals tight- no slop in bearings. Cuts something like 4 tpi to 72 tpi. Will make a nice starter lathe in ready-to-go condition. Asking $1000. Located midway between Baltimore and Philly . See Pix at http://users.zoominternet.net/~pcgray/lathe/atlas.html