kendall
Cast Iron
- Joined
- Dec 17, 2003
- Location
- grand rapids mi. usa
I located an old, but never used 3 jaw chuck, with both sets of jaws in my stash, came with a craftsman 618,(along with a bunch of other non-fitting stuff I haven't gone through yet)
it has a 1.5x8 mount (integral), and as far as I can tell has never even been on a lathe.
no name on it, says made in england, only has one key hole, no key, takes about a 5/16 key. has part numbers on it, along with a g# that's a different size than the rest of the stamps leading me to believe it was a grizzly item, quick check of the site didn't turn anything up though, plan on digging through the cartalog later.
for sale best offer, or prefer trade for a good 5-8" 4jaw with 2x8 mount (?-lathe it's for isn't available to check)
[This message has been edited by kendall (edited 01-14-2004).]
it has a 1.5x8 mount (integral), and as far as I can tell has never even been on a lathe.
no name on it, says made in england, only has one key hole, no key, takes about a 5/16 key. has part numbers on it, along with a g# that's a different size than the rest of the stamps leading me to believe it was a grizzly item, quick check of the site didn't turn anything up though, plan on digging through the cartalog later.
for sale best offer, or prefer trade for a good 5-8" 4jaw with 2x8 mount (?-lathe it's for isn't available to check)
[This message has been edited by kendall (edited 01-14-2004).]
