Hello there,
I really don't know much about EDM technology. I'm a gunsmith by trade and I'm planning in the near future to build a few receivers for break open single-shot rifles. There is a square slot in the receiver, about 1/4" x 3/4" and about 2 " deep. This slot hosts the locking bolt. I have drilled and broched it in the past, but what a nightmare that was. What approxi. whould it cost to have the slot EDM cut? Another question, if I would buy a machine to do it myself, what type of machine would you recommend me?
Thank you in advance for your feedback.
Toplever
I really don't know much about EDM technology. I'm a gunsmith by trade and I'm planning in the near future to build a few receivers for break open single-shot rifles. There is a square slot in the receiver, about 1/4" x 3/4" and about 2 " deep. This slot hosts the locking bolt. I have drilled and broched it in the past, but what a nightmare that was. What approxi. whould it cost to have the slot EDM cut? Another question, if I would buy a machine to do it myself, what type of machine would you recommend me?
Thank you in advance for your feedback.
Toplever