dazal
Plastic
- Joined
- Dec 14, 2006
- Location
- Auckland, New Zealand
Hey I am looking at using an EDM to accurately slicing tissue samples. I know it has been done before I think I will only need around 1-2A of current and the removal rate is not that important.
I was wondering if you could tel me what the power requirements for an EDM are?. I was thinking 300V 1A and around 1-3MHz frequency of pulses.
Can it be run of _+150V ? Other do you know where I can get an RF signal generator
I was wondering if you could tel me what the power requirements for an EDM are?. I was thinking 300V 1A and around 1-3MHz frequency of pulses.
Can it be run of _+150V ? Other do you know where I can get an RF signal generator