What's new
What's new

Robotool CVM-1 Operating Manual?

tsoper

Plastic
Joined
May 5, 2003
Location
Las Cruces, NM 88007
I have a ROBOTOOL CVM-1 CNC mill and am searching for a copy of the operating manual. Robotool went out of business years ago. I purchased the mill with two copies of the installation manual. I was able to get a copy of the programming manual from a company in Colorado. I have been able to set it up & run with Bobcad 17, but I still would like to have the original operating manual for reference.
 
Wow, you have one too. That's amazing. Do you need any software to read the CPM disks on a PC?
 
The factory guy that used too service those things and sell parts is Tom Nguyen . Last time I e-mailed him he was in the Dallas Fortworth area. He had plenty of parts to still support those things. His E-mail was something like : [email protected]
I hope this helps.
Good Luck
 
Hello

I just wanted to let you know that I just listed a Robotool CVM-1 CNC Control that I just removed from a Acer knee mill.

It is listed on E-bay as item# 250100344569 Or just do a search for Robotool.

Hope it is of interest.

Thanks

David Vande Berg
770 7th St. NW
Sioux Center, IA 51250
PH 712-722-1181 ext 112
FX 712-722-0900
Email [email protected]
 








 
Back
Top