We have a Deawoo Puma 200 barfeeder and it has been a fair machine, it's accurate but has had a few serious problems, a sensor switch went bad and caused the turret to rotate in the wrong direction and caused a 1.5" boring bar to hit the 3 jaw chuck spinning at about 2000 RPM, knocking the turret 1/32 out of alignment,several hyd. hoses have burst spraying fluid all over, the tailstock has never been very accurate because it never tightens down the same two times in a row so I can't just trust it to cut straight everytime, and the last problem it had the shaft that holds the turret on broke and had to be replaced. The fit and finish was never very good either and when it was new I had to beburr the turret where the blocks bolt on becaues the factory left burrs on all the holes and edges. I don't think I would recommend one.