TomM
Plastic
- Joined
- Mar 11, 2003
- Location
- Austin, TX
I recently bought a 93 Hurco Km? cnc machine with the dual screens and loaded Ultimax software with 4 axis.
The machine had a remote terminal that would allow for programming while the machine was running. This remote terminal was stolen.
I would like to load my PC with the same software and do the same.
I am not aware of any way to copy the software over from the machine.
Any suggestions?
Tom
The machine had a remote terminal that would allow for programming while the machine was running. This remote terminal was stolen.
I would like to load my PC with the same software and do the same.
I am not aware of any way to copy the software over from the machine.
Any suggestions?
Tom