JL Machine
Plastic
- Joined
- Mar 5, 2003
- Location
- Santa Clarita, CA, USA
Help! Help! Help!
I have a Sony Millstation control on my knee mill and I need a post processor to use with Mastercam. Mastercam has said that in order to get the post, I need to update my Mastercam version from 8 to 9 at a cost of $10,000. Since I am a small shop working out of my garage, this is out of the question. Does anyone have a post for my configuration or any other options for me?
Thanks,
Joe
I have a Sony Millstation control on my knee mill and I need a post processor to use with Mastercam. Mastercam has said that in order to get the post, I need to update my Mastercam version from 8 to 9 at a cost of $10,000. Since I am a small shop working out of my garage, this is out of the question. Does anyone have a post for my configuration or any other options for me?
Thanks,
Joe
