D. Rey
Titanium
- Joined
- Jan 20, 2003
- Location
- Phoenix, AZ
The lathe is a QT-8 T2 control.
I've tried several times to program L-R cutting with a L-R tool to clean out areas left over with a R-L tool. I always get a "reverse contour " error or "reverse shape error". I've just been using a groove tool to get the job done. Is there a trick to getting a T2 to do L-R OD turning?
I've tried several times to program L-R cutting with a L-R tool to clean out areas left over with a R-L tool. I always get a "reverse contour " error or "reverse shape error". I've just been using a groove tool to get the job done. Is there a trick to getting a T2 to do L-R OD turning?