Verify tool for integrex?

Shawn D. · Jun 24, 2006

I know that there are alot of difernt verify softwares out there for eia programs, but is there any that will simulate a integrex? I find now that it is hard to tell what your program is going to do until you actully get it on the machine.

newtexas2006 · Jun 25, 2006

You can try Griffro Brother or Solutionware

Shawn D. · Jun 26, 2006

I am looking for a tool to verify g-code

chaz_cam · Jun 26, 2006

Direct from Mazak... GibbsCam is the hot ticket for full blown CAD/CAM. UGS is their preferred verifier only

peskapatch · Jul 6, 2006

Hello,

Vericut will simulate the integrex. not sure how to set it up.

I've ran many software "proven" programs that would have or did make bad parts.

Only way to prove the code is to run it. Experienced people at the control is far better than any software. not to say the software is bad or people programming for that matter, just saying it is mearly a "safety" net that sometines isn't so safe.

Will.

Shawn D. · Jul 7, 2006

Vericut will simulate the integrex. not sure how to set it up.

I was thinking of trying that, but I wouldnt know where to start with setting it up.

Joe788 · Jul 7, 2006

Shawn, I believe Vericut is a "partner" with Mazak, and will supply the completely modeled machine. You just have to define the stock, define your tools, and then let her rip. As long as you've got everything defined properly, it will properly verify your program. It's a pretty neat piece of software, but it's a little pricey.

Shawn D. · Jul 10, 2006

Thanks joe, i didnt realize that, im looking into it now.

Search

Largest Manufacturing Technology Community on the Web

Search

Verify tool for integrex?

Shawn D.

Plastic

newtexas2006

Aluminum

Shawn D.

Plastic

chaz_cam

Plastic

peskapatch

Plastic

Shawn D.

Plastic

Joe788

Titanium

Shawn D.

Plastic

Similar threads