TXClark
Plastic
- Joined
- Jul 25, 2006
- Location
- Leander TX
I started working at an area shop back in february (medical device stuff mainly) and still have not had much time to learn how to setup the programs on our mazak lathes (Fusions and T Plus). The lead guys here have pretty large work loads lately and it seems like I may never get a chance to go over it with them.
I've looked around online and have not found much. I can do some basic setups on the machine (tooling and fixtures etc) but they will usually have the program already and I just run the job and on to the next one afterwards. I'm eager to learn but get confused the few times I've looked over their shoulders to watch.
any info leading me in the right direction is greatly appreciated! Need one of those idiot's guides to mazatrol
I've looked around online and have not found much. I can do some basic setups on the machine (tooling and fixtures etc) but they will usually have the program already and I just run the job and on to the next one afterwards. I'm eager to learn but get confused the few times I've looked over their shoulders to watch.
any info leading me in the right direction is greatly appreciated! Need one of those idiot's guides to mazatrol