bjjmachinist
Plastic
- Joined
- Nov 18, 2006
- Location
- usa
Left the machine down to long without power and lost parameters. I have reinitailized and reloaded the parameters I had which were just for the x,y,z axis. I did find a handwritten note in the manual that the 4th axis parameters GDR should be 13 and the SQ2 should be 16. This made the 4th axis operational but when it turns 90 degrees it says it is only 15 so I dont have the increment set correctly and also had to give a couple parameters numbers so it had a feed value to home out and for rapid moves. Anyone have an m2 with 4th axis parameters or anything that might shed some light on this would be greatly appreciated?