position display

seth · Feb 17, 2007

We have an Integrex 200 mark 4 and I was wondering if anyone new of a parameter to change the position display to an absolute position that didn't apply an offset value to it.

Ex: If you cut a part programmed at 2.500 and have an offset of .005 in it, the position shows 2.505.

jimmyb · Feb 17, 2007

Hallaluyah, That is a pain with all the Turn centers. Don't know why they did that. You're still actually turning at 2.5", just needed to comp for tool wear. I've never heard of a work around, but I'm curious to see what others say.

ChampionP · Feb 17, 2007

On the matrix control and the fusion control if you hit the right arrow you should see "command" in the display. activate or disable it to change the positional displays.

wippin' boy · Feb 17, 2007

your home positon is off
ZP on the older controls
would have to look up newer ones

Search

Largest Manufacturing Technology Community on the Web

Search

position display

seth

Aluminum

jimmyb

Aluminum

ChampionP

Cast Iron

wippin' boy

Diamond

Similar threads