G10 ?

Is there such a thing on HAAS lathes as there is on Fanuc?

Werk the same?


--------

Think Snow Eh!
Ox

On my SL-20 it is listed as a programmable offset setting. I've never used it though.

Ox:

The HAAS manual describes G10. If you lack the manual you can find it on line.

If you have macros you can directly load a variable that corresponds to a particular offset, etc. Again see the manual for a fairly good list of the variables under MACROS.

You can also save and load the offset table via RS232.

Also G52 in either HAAS or Fanuc mode is very useful.

I believe you have slow access to the internet so it would be better to get a printed manual from HAAS. Maybe you could go to a local library and download the HAAS manual and put it on disk for reference. The mill manual is about 12 megs, and the lathe about 7 megs.

.

Actually - I am "online" now - as of maybe two months ago.

We were supposedly out in SAT territory, but we did git someone to try DSL on us and it werks. Maybe not as good as uptown, but definately an upgrade for us!

--

Anyway - I don't have a HAAS, but my chumms just bought one and I just wanted to give them some pointers is all. Just wanted to know if they had that feature and if it werked the same as Fanuc.

G10 P0 X0 Z-2.5

This would werk on the HAAS the same as the Fanuc eh?


--------

Think Snow Eh!
Ox

Ox:

Quote from HAAS manual:

G10 Set Offsets (Group 00)
G10 allows the programmer to set offsets within the program. Using G10 replaces the manual entry of offsets (i.e.
Tool length and diameter, and work coordinate offsets).
L – Selects offset category.
L2 Work coordinate origin for G52 and G54-G59
L10 Length offset amount (for [FONT=SansSerif,Bold]H [/FONT]code)
L1 or L11 Tool wear offset amount (for [FONT=SansSerif,Bold]H [/FONT]code)
L12 Diameter offset amount (for [FONT=SansSerif,Bold]D [/FONT]code)
L13 Diameter wear offset amount (for [FONT=SansSerif,Bold]D [/FONT]code)
L20 Auxiliary work coordinate origin for G110-G129
P – Selects a specific offset.
P1-P100 Used to reference [FONT=SansSerif,Bold]D [/FONT]or [FONT=SansSerif,Bold]H [/FONT]code offsets (L10-L13)
P0 G52 references work coordinate (L2)
P1-P6 G54-G59 references work coordinates (L2)
P1-P20 G110-G129 references auxiliary coordinates (L20)
P1-P99 G154 P1-P99 reference auxiliary coordinate (L20)
R Offset value or increment for length and diameter.
X Optional X-axis zero location.
Y Optional Y-axis zero location.
Z Optional Z-axis zero location.​

A Optional A-axis zero location.

Click to expand...

.

I believe that's a "yes".

------

Think Snow Eh!
Ox