Chip auger problems

wildchild · May 7, 2008

HAAS 1995 vf-0 the chip auger quit all of a sudden.

I used a ac meter to check and see if there was any power coming from out of the back of the machine. There doesn't seem to be any power going to the motor.

Anyone have any ideas were to look for any problems like relays maybe?

wildchild · May 21, 2008

anyone?. any ideas?

jetcutter · May 21, 2008

All I can tell you is,, I used to use a saw with an chip removal auger. The power for the auger came from the coolant pump in my case, However it may very well come from a plc unit. do you have schematics?

DPPMFG · May 22, 2008

Mine has a fuse to power it same with the coolant pump it blows out every time we stall out the pump. Just clean out the pump replace the fuse and go again.

wildchild · May 23, 2008

Checked all the fuses and switched around the relays still nothing. I followed the circuits on the board best I could and it all looked good.

I'm puzzled.

Cheenist · May 30, 2008

On my '94 VF-2 the switch for the chip auger is at the top-front of the right door. Sometimes when the door is slammed hard the switch gets moved and will not allow the auger to come on. Switch not made=no chip auger.
Good luck,
Carl

Search

Largest Manufacturing Technology Community on the Web

Search

Chip auger problems

wildchild

Plastic

wildchild

Plastic

jetcutter

Plastic

DPPMFG

Plastic

wildchild

Plastic

Cheenist

Hot Rolled

Similar threads