GBeaman
Hot Rolled
- Joined
- Jun 13, 2006
- Location
- Marble Falls, TX
I found this 208v-120/240V buck transformer and was wondering if it will suit my needs. I have about 244 volts on my RPC incoming. I would like to get that down below 220. The calculation I did was:
If I wanted to go from 250-220 at 100AMPS I get 5190VA That is roughly 5KVA right?
My line fluctuates from 242-250 depending on the temp, and I would much rather be a bit lower then 220 rather than higher. Will this suit my needs. Can I tap my 2 phases to the 120-240 side and then tap the other side as output, and have somewhere in the right ball park with enough KVA to suit? Hope I am making sense. Thanks.
_Greg
If I wanted to go from 250-220 at 100AMPS I get 5190VA That is roughly 5KVA right?
My line fluctuates from 242-250 depending on the temp, and I would much rather be a bit lower then 220 rather than higher. Will this suit my needs. Can I tap my 2 phases to the 120-240 side and then tap the other side as output, and have somewhere in the right ball park with enough KVA to suit? Hope I am making sense. Thanks.
_Greg