What's new
What's new

Putting in my own chip augers

Mike Ortega

Aluminum
Joined
Aug 20, 2007
Location
Sunnyvale, Ca
Well, to make a long story short, chip augers on out vf2ss's were overlooked, then ordered a few weeks later. Tech is coming in tomorrow to set-up machines, but the augers are in a wharehouse in Tracy. Boss requsted overnite air to get'em here in time, someone mistook that for ground which will get them here next week. SO, the way i see it, all we have to do is remove the deletion plates, mount the motor on the right side using the gasket that came with the plate, slide the auger in from the left side, or if space permits from above. Couple the auger to the motor, attach the discharge chute to the left side with gasket, run the wire to the cabinet, and turn the auger on in the parameters. Any suggestions or tips?

-I think I made a short story long.
 
On Track

You nailed it, thats all I did when we ordered one. Don't forget to hit e-stop when in the peramiters, had to call HAAS after six hours of scratching our heads!!!:willy_nilly:
 








 
Back
Top