ARB
Titanium
- Joined
- Dec 7, 2002
- Location
- Granville,NY,USA
I've got a 1994 VF3 and I'm wondering if there are things to take care of with the DC servo motors? The machine has about 14,000 hours on it.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
DC motor maintenance
- Thread starter ARB
- Start date
- Replies 2
- Views 1,393
sudtechcnc
Cast Iron
- Joined
- Mar 13, 2007
- Location
- chennai ,south india
Hmm I think you cant do much harm by pumping some compressed air(DRY !) into the motor while removing the side covers(if there are any) without disassembling the motor)...
Be sure to wear a GAS MASK !
MJM
Be sure to wear a GAS MASK !
MJM
sudtechcnc
Cast Iron
- Joined
- Mar 13, 2007
- Location
- chennai ,south india
On second thoughts ARB.. It wouldn't be such a good idea..
because if its more than 10 years old,chances are that the insulating material would have started to or have turned brittle. and high pressure air will just remove the material off the coils.
So maybe low pressure air (maybe a blower ) instead of compressed air).
MJM
because if its more than 10 years old,chances are that the insulating material would have started to or have turned brittle. and high pressure air will just remove the material off the coils.
So maybe low pressure air (maybe a blower ) instead of compressed air).
MJM