silvfox12000
Plastic
- Joined
- Aug 22, 2008
- Location
- Livingston, TX
This is my first post. Hello to everyone.
I am building my first Rotary Phase Converter. I have a small problem.
The motor is a 25hp 220 three phase. I do not have any wiring diagram hook-up, neither is there a plate on the motor. It came off a Lathe.
There are six wires under the cover plate. I need to know which three wires are for the hook-up. They are number as follows.
On the top row numbetred: A2 - C2 - B2
On bottom row number: C1 - B1 - A1
So does anyone know which ones I connect to to get the motor to work.
Which two are for the running circuit and which one is for the generated lead.
Thanks
I am building my first Rotary Phase Converter. I have a small problem.
The motor is a 25hp 220 three phase. I do not have any wiring diagram hook-up, neither is there a plate on the motor. It came off a Lathe.
There are six wires under the cover plate. I need to know which three wires are for the hook-up. They are number as follows.
On the top row numbetred: A2 - C2 - B2
On bottom row number: C1 - B1 - A1
So does anyone know which ones I connect to to get the motor to work.
Which two are for the running circuit and which one is for the generated lead.
Thanks
