D. Rey
Titanium
- Joined
- Jan 20, 2003
- Location
- Phoenix, AZ
Machine is a 94 Nakamura TMC-15 lathe
wiring diagram from manual, left side looks like my setup, right side appears to have an external transformer?
wires from shop into base, to taps labeled Ro,So,To, to top of circuit breaker and out to machine.
This is what I am uncertain of. Pic is of the transformer to the right of the circuit breaker in the above picture.
Looks obviously like transformer taps, S3 was on 210, I moved it to 230 as I have 240V in, I left the screw on 210 out so there are no missing screws, no loose wires. Where is the third leg? There is no mention of this particular transformer in the book I just ASSume it's the machine transformer, think this is correct?
I have not put power to the machine yet.
wiring diagram from manual, left side looks like my setup, right side appears to have an external transformer?
wires from shop into base, to taps labeled Ro,So,To, to top of circuit breaker and out to machine.
This is what I am uncertain of. Pic is of the transformer to the right of the circuit breaker in the above picture.
Looks obviously like transformer taps, S3 was on 210, I moved it to 230 as I have 240V in, I left the screw on 210 out so there are no missing screws, no loose wires. Where is the third leg? There is no mention of this particular transformer in the book I just ASSume it's the machine transformer, think this is correct?
I have not put power to the machine yet.