mbraddock
Hot Rolled
- Joined
- Jul 17, 2008
- Location
- Gainesville, FL
We've ordered a TM-2 that will be here in a few weeks. I'm trying to decide whether we need to hire a rigger or not. The machine on its skid weighs approximately 4100 pounds. Does anyone know Haas' recommendation for lifting the TM-2 off its skid? They sent the general page on lifting their vertical CNC mills from underneath with a forklift, but I was curious if anyone has more specific instructions or wisdom after doing this themselves.
Thanks in advance for any advice you can offer!
Mike
Thanks in advance for any advice you can offer!
Mike