Haas 5C indexer

Granite · Apr 10, 2009

I have an older Haas 5C indexer that keeps blowing a fuse in the controller.
Might be the servo. Haas does not support this indexer anymore.
Any recommendations for a place that fixes them?

SeymourDumore · Apr 10, 2009

Are you sure Haas does not support these indexers?
They may not sell it but not supporting it?

Granite · Apr 10, 2009

I called a few years ago and was told they don't support/sell parts for it.
It has a UK servo.

SeymourDumore · Apr 10, 2009

Did you call Haas in CA or the local HFO?
I seem to recall a bunch of older controls and indexers repaired, disassembled and waiting to be disassembled for repair in the Trident facility in Windsor CT.
Give them a call. The # is 1-888-622-4857

Granite · Apr 10, 2009

I called CA. I will try the CT number, thanks.

machinist_650r · Apr 10, 2009

check the cable when the fuse goes out it might be a short that is causing it
so you just need to replace the cable

kustomizer · Apr 11, 2009

Ours did something similar once and it turned out the motor got bumped putting it away or something. Anyhow there are 4 bolts you can loosen then run a rotating program for a bit and it will self center and you can retighten them. The only other thing I can think of is brush dust in the motor, or wires as mentioned before.

Volitan · Apr 14, 2009

You can try Allendale in Jersey. 201-327-5215

Ask for Martin, he's their 4th axis/indexer guy and he's real good with the older ones as well. He's helped us with our older one in the past.

Search

Largest Manufacturing Technology Community on the Web

Search

Haas 5C indexer

Granite

Aluminum

SeymourDumore

Diamond

Granite

Aluminum

SeymourDumore

Diamond

Granite

Aluminum

machinist_650r

Plastic

kustomizer

Diamond

Volitan

Hot Rolled

Similar threads