Had a turret crash. Hit the wrong button and spun the turret backwards
into a 1" piece of aluminum. at first it would not seat properly, I tried the things listed in the manual and finally after a big pop the turret would seat. Now it chirps at every tool change and the tool center is about 1/4" low.
How do you make this adjustment, and how hard is it to rebuild the turret. Now there is part of a o-ring hanging out behind the turret.
this is a haas hl-2
thanks
into a 1" piece of aluminum. at first it would not seat properly, I tried the things listed in the manual and finally after a big pop the turret would seat. Now it chirps at every tool change and the tool center is about 1/4" low.
How do you make this adjustment, and how hard is it to rebuild the turret. Now there is part of a o-ring hanging out behind the turret.
this is a haas hl-2
thanks