StreetSpeed
Hot Rolled
- Joined
- Oct 15, 2008
- Location
- NY
Folks,
This probably isn't Haas specific, but I don't know the answer to this basic question: How can I reduce the offset of my tool as it's moving through the program? I want to spread out .0007 tool wear over 15 parts, so is that something I do in the code or is there a feature I can access on the control? These are on 2006 and newer VF-2, and VF-3s, and VF-5.
This probably isn't Haas specific, but I don't know the answer to this basic question: How can I reduce the offset of my tool as it's moving through the program? I want to spread out .0007 tool wear over 15 parts, so is that something I do in the code or is there a feature I can access on the control? These are on 2006 and newer VF-2, and VF-3s, and VF-5.