What's new
What's new

Mini-mill table space

ap_precision

Plastic
Joined
Nov 5, 2008
Location
Illinois
Hello to all! Is it feasible to use two Kurt double-lock vises on a mini-mill table. I'm sure they will fit, but I dont want to run the back/front edge into any guarding. Thank You! Aaron
 
I Run Two Chick QL4's all the time on our Mini..

I did re drill the sine key hole in the bottom of the vices to move the key to a location as to not allow the back of the vices to hit the rear Z axis guard at full travel...

Not the same as the Kurts but would give you an Idea..
 








 
Back
Top