joker
Aluminum
- Joined
- Sep 2, 2006
- Location
- central Pennsylvania
Trying to tap 17-4 stainless (H1100 condition) using a 3/4-6 Left hand acme tandem tap.
Machine is a TL-25. Hole size is correct. RPM is ~250, feed is .16667" per rev.
We are getting a 105 alarm (Z axis servo to large). Checked incoming voltage and the parameters match factory settings.
Local Haas dealer said there is not a lot they can do for us. Any suggestions?
I find it hard to believe we can not run this tap with this machine.
Thanks,
Joker
Machine is a TL-25. Hole size is correct. RPM is ~250, feed is .16667" per rev.
We are getting a 105 alarm (Z axis servo to large). Checked incoming voltage and the parameters match factory settings.
Local Haas dealer said there is not a lot they can do for us. Any suggestions?
I find it hard to believe we can not run this tap with this machine.
Thanks,
Joker