deerepower74
Plastic
- Joined
- Dec 27, 2009
- Location
- Maquoketa, IA
A few months back we purchased a TL-2. One concern we have is the lack of guarding to keep chips and coolant from falling on the carriage ballscrew and floor behind the machine. The only guard there is to stop chips and coolant is mounted to the carriage which leaves the back of the lathe open to allow chips and coolant to escape the "full enclosure". Has anyone found a way to remedy this? We have looked into roll-up and accordian covers but haven't found any to really work well in this application.
Last edited: