I am looking at the Haas Mini-mill2 and see that the spindle uses air/oil for lubrication and cooling. How much air and oil does it consume? Does it just use air pressure to push the oil or does it mist the oil through the bearings?
I did not really want to have the machine constantly consuming air and running the compressor constantly. Is it like leaving an air gun open continuously? Or equal to a blast of air a few times a minute?
Also, how much oil is used and where does the used oil go? Is it consumed or recirculated?
Thanks,
Glenn
I did not really want to have the machine constantly consuming air and running the compressor constantly. Is it like leaving an air gun open continuously? Or equal to a blast of air a few times a minute?
Also, how much oil is used and where does the used oil go? Is it consumed or recirculated?
Thanks,
Glenn