Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Haas tm1 without tool changer air requirements
- Thread starter MBG
- Start date
- Replies 5
- Views 2,605
behindpropellers
Stainless
- Joined
- Dec 16, 2008
- Location
- NE OHIO
Just about any run of the mill home compressor will work. It only uses air on tool changes.
Tim
Tim
Thanks, so no tool changer machine will mean no need for air correct?
Kevin Wilkins
Cast Iron
- Joined
- Aug 19, 2003
- Location
- Berlin, Germany
You need a compressor, but as was said above, just about any compressor will be fine. If the machine looses air pressure while running it stops. Not good.
behindpropellers
Stainless
- Joined
- Dec 16, 2008
- Location
- NE OHIO
haastec
Hot Rolled
- Joined
- Mar 8, 2010
- Location
- Southwest, USA
+1 You need air to clamp/unclamp the tool.
