I have a 2004 VF2 with 16M upgraded memory.
I am using an xlTransfer from DNC, xlTRANSFER
to allow me to use USB memory sticks and upload files via the RS232 port.
It's working well with small files, but not with anything larger than would usually fit on a floppy...
I am wondering if it is a setting on the control?
I tried uploading a file that was 2.5m and got an error saying missing (...) and then in the alarms it said it was trying to load data as a comment?
I checked the file thoroughly, including the line it seemed to have an issue with, and couldn't see any problem.
I broke EXACTLY the same file down into smaller parts of no more than 1.34M, and it went through just fine.
The xlTransfer seems to be happy sending the larger file, but the Haas controller doesn't seem happy receiving it after it gets above a certain size.
Any thoughts?
Thanks
btw. Made my first chips with this, my first CNC, last night and it was awesome!
I am using an xlTransfer from DNC, xlTRANSFER
to allow me to use USB memory sticks and upload files via the RS232 port.
It's working well with small files, but not with anything larger than would usually fit on a floppy...
I am wondering if it is a setting on the control?
I tried uploading a file that was 2.5m and got an error saying missing (...) and then in the alarms it said it was trying to load data as a comment?
I checked the file thoroughly, including the line it seemed to have an issue with, and couldn't see any problem.
I broke EXACTLY the same file down into smaller parts of no more than 1.34M, and it went through just fine.
The xlTransfer seems to be happy sending the larger file, but the Haas controller doesn't seem happy receiving it after it gets above a certain size.
Any thoughts?
Thanks
btw. Made my first chips with this, my first CNC, last night and it was awesome!