CamSweet
Plastic
- Joined
- Jun 2, 2010
- Location
- Seattle, WA
All,
I started a new job and in the Model Shop is an older TM-1. It has IPS and a Renishaw Probing System. I don't claim to be a machinist, but can get my way around a manual mill and lathe. There isn't anybody here that can run the TM-1. It was originally installed and programmed to run one part and is now not needed. I've been poking around it a bit. I read the IPS overview and have gone to the Work Setup page and guess I just ssumed that the Renishaw would have turned on during this page. I talked to a tech and wrote a line of code and verified that I could indeed turn it on and off and that it's functional when on. Is it supposed to turn on in the Work and Tool Setup pages? Is there an M code to turn on the Tool Offset Sensor, just as there was to turn the spindle probe on/off?
Thanks guys...
Cam
I started a new job and in the Model Shop is an older TM-1. It has IPS and a Renishaw Probing System. I don't claim to be a machinist, but can get my way around a manual mill and lathe. There isn't anybody here that can run the TM-1. It was originally installed and programmed to run one part and is now not needed. I've been poking around it a bit. I read the IPS overview and have gone to the Work Setup page and guess I just ssumed that the Renishaw would have turned on during this page. I talked to a tech and wrote a line of code and verified that I could indeed turn it on and off and that it's functional when on. Is it supposed to turn on in the Work and Tool Setup pages? Is there an M code to turn on the Tool Offset Sensor, just as there was to turn the spindle probe on/off?
Thanks guys...
Cam