dstankus14
Plastic
- Joined
- Oct 2, 2017
I recently bought an Alliant RT2 mill which was set up to run off 440V 3PH. I will be purchasing a VFD to take my 220 single phase and convert it to 220 3PH. looking into the wiring enclosure I see the attached. The name plate on the motor looks like it should have a wiring diagram but either it never did or it wore off somehow. Anyone have suggestions how I can get this set up?
Also there are two fans located on the back of the head and it looks like they are not connected. I haven't checked yet if the fans are still good - but they seem to have been disconnected. Any ideas on how these should be connected? There are just two leads - my guess is that this would be a single 220 pole maybe?
I attached the motor name plate info and what is in the wire connection box. Any help would be appreciated.
Also there are two fans located on the back of the head and it looks like they are not connected. I haven't checked yet if the fans are still good - but they seem to have been disconnected. Any ideas on how these should be connected? There are just two leads - my guess is that this would be a single 220 pole maybe?
I attached the motor name plate info and what is in the wire connection box. Any help would be appreciated.