Hey everyone. I don't post much because I can usually find the answers from past posts. But I have an issue I can't figure out.
I have a Torq-Cut 30 with DX32 control (the last revision) and the manual feed rate knob on the console stopped working. When I try to adjust the feed rate with the console knob, the % change does show up on the screen (so it's not the knob itself) but the machine ignores it. I haven't changed or messed with anything on the machine. Any ideas? To add, the spindle speed adjust still works.
I have a Torq-Cut 30 with DX32 control (the last revision) and the manual feed rate knob on the console stopped working. When I try to adjust the feed rate with the console knob, the % change does show up on the screen (so it's not the knob itself) but the machine ignores it. I haven't changed or messed with anything on the machine. Any ideas? To add, the spindle speed adjust still works.
