tallcar
Plastic
- Joined
- Mar 12, 2013
- Location
- Northeast Indiana
We found, like others, a very nice Bridgeport R2E4 machine. Powers up, all axis's move manually, CRT works, spindle turns, BUT.
Yeah one of those..lol We were not offered any tooling with this machine. I am learning that one can either find the Erickson and use the locking collar OR one can use the NMTB 30 tooling with a 1/2-13 draw bar. Does anyone know the correct length of said draw bar that we do not have?
Recommendations of where one could buy said draw bar? At this point I would only need a holder that will hold a 3/4 arbor as this machine will be dedicated to one job for like 7 years...Other tooling would be "acquired" as needed, but I need this to get the project rolling.
Been machining for 33 years, never seen the tool holding system.
Thanks
Richard
Yeah one of those..lol We were not offered any tooling with this machine. I am learning that one can either find the Erickson and use the locking collar OR one can use the NMTB 30 tooling with a 1/2-13 draw bar. Does anyone know the correct length of said draw bar that we do not have?
Recommendations of where one could buy said draw bar? At this point I would only need a holder that will hold a 3/4 arbor as this machine will be dedicated to one job for like 7 years...Other tooling would be "acquired" as needed, but I need this to get the project rolling.
Been machining for 33 years, never seen the tool holding system.
Thanks
Richard