regcabdak
Cast Iron
- Joined
- Jan 9, 2008
- Location
- northern california
With the talk about the small Hardinge mills going around, my interest in the Cataract No.5 mill has been renewed.
I can't seem to find any info about them other then on the Lathes.co.uk site. From the picture, I can't tell if it has power feed or not, but I'm guessing it does. Does anyone know if any examples of this mill are still around? Larry, I know you seem to have almost every Hardinge/Cataract item ever made, you happen to have one?
I would like to get one of these mills as it would match my Quick Change lathe with the little cupboard, and be very handy to have a horizontal mill in the shop since I only have a vertical mill.
Any info would be appreciated!
Tyler
I can't seem to find any info about them other then on the Lathes.co.uk site. From the picture, I can't tell if it has power feed or not, but I'm guessing it does. Does anyone know if any examples of this mill are still around? Larry, I know you seem to have almost every Hardinge/Cataract item ever made, you happen to have one?
I would like to get one of these mills as it would match my Quick Change lathe with the little cupboard, and be very handy to have a horizontal mill in the shop since I only have a vertical mill.
Any info would be appreciated!
Tyler