I'm sure I could figure it out if I was at the machine, but while sitting here drinking morning coffee 16 miles away, just wondering what the procedure is.
I presume the attachment, which is at present slid all the way to the right side and not connected, is slid to aprox where you need it, the slide block is bolted to the end of the cross slide....but how do you disconnect the cross screw nut from the cross slide and/or any other "tips" one might have in that regard ?
I presume the attachment, which is at present slid all the way to the right side and not connected, is slid to aprox where you need it, the slide block is bolted to the end of the cross slide....but how do you disconnect the cross screw nut from the cross slide and/or any other "tips" one might have in that regard ?