bradjacob
Titanium
- Joined
- Nov 18, 2008
- Location
- Easton, PA
Need some help here. I finally got my Bridgeport up and running, but when I went to install a collet, I found that the pin inside the spindle was all but gone. What remains is a rounded-over just high enough for me to feel it. Needless to say, it's not holding the collet, so I can't tighten an end mill into it.
Does anyone know what's involved in getting a new pin in there? Or is there some workaround that people do?
Any info would be greatly appreciated.
Does anyone know what's involved in getting a new pin in there? Or is there some workaround that people do?
Any info would be greatly appreciated.