A
<axs460>
Guest
I recently purchased a 2002 Sharp milling machine. I have put together a list of tooling and supplies that are needed, but am curious in regards to the lubricants recommended in the user manual.
The following lubricants are listed for designated positions.
1. Esso Febis K-53 => Head Stock Matching Quill Holes
2. Gulf Way 52 => Bull Gear Bearing Sleeve
3. Vactra #2, Shell Tonna 33 => Counter Shaft Gear, Worm Gear Cradle
Note: (Lubrication of work table, saddle, knee, sliding surface and leadscrews may be effectuated by means of the hand crank pump)
I have searched for the lubricants but could only find Vactra #2.
So, my question is. . .Can I use Vactra #2 as the lubricant for the one shot lube AND all the other lubrication positions? If not, does anyone know where I can find the necessary lubricants, or an equivalent? Thanks for the help.
The following lubricants are listed for designated positions.
1. Esso Febis K-53 => Head Stock Matching Quill Holes
2. Gulf Way 52 => Bull Gear Bearing Sleeve
3. Vactra #2, Shell Tonna 33 => Counter Shaft Gear, Worm Gear Cradle
Note: (Lubrication of work table, saddle, knee, sliding surface and leadscrews may be effectuated by means of the hand crank pump)
I have searched for the lubricants but could only find Vactra #2.
So, my question is. . .Can I use Vactra #2 as the lubricant for the one shot lube AND all the other lubrication positions? If not, does anyone know where I can find the necessary lubricants, or an equivalent? Thanks for the help.