GeorgeToolmaker
Aluminum
- Joined
- May 24, 2014
- Location
- Charleston,SC
I just took delivery of an older (early 90's) Bridgeport with a MillPWR 2 axis control. It was working fine. I powered it down. It sat for A week or so then up in attempting power up, it have me an error.Something about it a communication problem with the keyboard and to press F1 to continue. The control doesn't have an F1 key so I powered down to re-boot. When I try to bring it back up, it beeps 10 times then pauses then beeps 10 times again and repeats this cycle. I have tried powering down and up several times with the same result. Is this an alarm? Is it possible that a battery died and I lost my start up procedure? Any help would be GREATLY appreciated!!!
Last edited: