nearbeer
Plastic
- Joined
- Jul 29, 2009
- Location
- Greenville, SC
Thanks for your time.
Worked on the mill after a long winter break...I know, it's almost summer so sue me...
I was able to get the head, turret/ram, and table off today but had to stop due to rain (covered up my work thank you very much) and had an issue with the bracket that hold the x & y feed nuts.
Getting the socket head screws out was not a problem but as I attempted to pull up the bracket and rotate it 90 degrees to remove it, I noticed two small pins in between the screw holes that didn't allow the bracket to come up cleanly for rotation.
Any thoughts on what to do with those pins? Do I take a small punch and drive the through the bracket and into the saddle? Any and all advice is greatly appreciated!
Look for more beer,
NearBeer
Worked on the mill after a long winter break...I know, it's almost summer so sue me...
I was able to get the head, turret/ram, and table off today but had to stop due to rain (covered up my work thank you very much) and had an issue with the bracket that hold the x & y feed nuts.
Getting the socket head screws out was not a problem but as I attempted to pull up the bracket and rotate it 90 degrees to remove it, I noticed two small pins in between the screw holes that didn't allow the bracket to come up cleanly for rotation.
Any thoughts on what to do with those pins? Do I take a small punch and drive the through the bracket and into the saddle? Any and all advice is greatly appreciated!
Look for more beer,
NearBeer