boosted
Stainless
- Joined
- Jan 4, 2014
- Location
- Portland, OR
Just got done with a FeatureCAM demo, and we were really impressed. What other software should we be considering for turning? We do a lot of low volume, high complexity parts.
We have Esprit 20xx, but it's just not up to the challenge anymore. The age of the software is really starting to show, especially with 5 axis milling on the millturns.
We have a couple of DMG MORI NTX platforms with lower turrets, 2 sub-spindle Y-axis lathes, and a Citizen. Multi channel support, and good simulation are critical.
I'm looking for insight from other users who like to push the limits of their machines and software. Are there any premium platforms we may not have considered? Would like to make sure we haven't missed anything, before giving FeatureCAM a whirl.
We have Esprit 20xx, but it's just not up to the challenge anymore. The age of the software is really starting to show, especially with 5 axis milling on the millturns.
We have a couple of DMG MORI NTX platforms with lower turrets, 2 sub-spindle Y-axis lathes, and a Citizen. Multi channel support, and good simulation are critical.
I'm looking for insight from other users who like to push the limits of their machines and software. Are there any premium platforms we may not have considered? Would like to make sure we haven't missed anything, before giving FeatureCAM a whirl.