CAm post processor can cover 4th rotary control?

Kevin Montreal · Jun 25, 2014

hello,

Basic on our new order, We need install new 4th rotary table to 3 axis milling machine. So My question is CAm post processor can cover rotary control normally? For example. If we install HAAS rotary HA5C to OKK machine, CAM post processor can cover OKK control and HAAS control same time? It is possible or does work!

Thanks!
Kevin

Diezel · Jun 25, 2014

Your post should handle it... If it doesn't change the post to.. Also you could just code the angle changes by hand.
And I'm pretty sure the machine controls the fourth so it must be set up in the machine controller to handle the 4th then you program by controller the way you have been..

g-coder05 · Jun 26, 2014

Haas will only work on Haas unless you buy the control box from has that is programmable for positioning only via an M code shot from your OKK. You can not to contouring with the Haas on any other brand of machine. You should look at a troyk, SMW or another after market brand that can tie in directly to your axis card. Your machine does have a A axis drive correct?

Search

Largest Manufacturing Technology Community on the Web

Search

CAm post processor can cover 4th rotary control?

Kevin Montreal

Plastic

Diezel

Aluminum

g-coder05

Titanium

Similar threads