Jerome227837
Plastic
- Joined
- May 3, 2018
My very first post here.
I am not very knowledgeable about machining but I have one of these old hogs. My father was a Tool maker and I hve 3 brothers who are Tool makers so hopefully they can give me some good advice. Anyway, the feed on this #2 has stopped. Neither the automatic feed nor the manual feed will work on the vertical knee. The X&Y has both worked until recently when the Y also stopped working. My guess is that a pin has sheared off but that’s just a guess. Would anyone have suggestions? Thanks in advance!!
I am not very knowledgeable about machining but I have one of these old hogs. My father was a Tool maker and I hve 3 brothers who are Tool makers so hopefully they can give me some good advice. Anyway, the feed on this #2 has stopped. Neither the automatic feed nor the manual feed will work on the vertical knee. The X&Y has both worked until recently when the Y also stopped working. My guess is that a pin has sheared off but that’s just a guess. Would anyone have suggestions? Thanks in advance!!