crzypete
Hot Rolled
- Joined
- Jun 8, 2003
- Location
- New York State
An exciting day for me, I just picked up this mill to upgrade my older cincinnati horizontal mill. It was a long drive off to Cleveland, but hopeful a fruitful one. The company claimed it ran flawlessly, but it was no longer hooked to power when I arrived.
I am most thrilled about the powered overarm!
Unfortunately the table raising handle is MIA and there are no overarm supports. Any one with any leads? Any idea on how universal the overarm supports are?
I've never experienced the hydraulic feed system, hopefully it will not be too much of a nightmare.
The serial number is 12J2P5P-26.
Does anyone have experience with these? Has anyone mounted a DRO?
Peter
I am most thrilled about the powered overarm!
Unfortunately the table raising handle is MIA and there are no overarm supports. Any one with any leads? Any idea on how universal the overarm supports are?
I've never experienced the hydraulic feed system, hopefully it will not be too much of a nightmare.
The serial number is 12J2P5P-26.
Does anyone have experience with these? Has anyone mounted a DRO?
Peter