Miguels244
Diamond
- Joined
- Mar 27, 2011
- Location
- Denver, CO USA
So, I finally pulled the trigger...the vert head and all three overarm supports were the kicker.
Milwaukee Kearney Trecker Horizontal Vertical Milling Machine | eBay
Now to start tooling up.
Silly question time.
I think this is NMTB 50...Yes?
I figure a vise and a clamp set, perhaps an miteebite set too.
Parallels.
A long tool holder.
A short tool holder.
TG or ER collets? 100 or 150?
A shell mill holder...how many different sizes of those are there?
It has an arbor, how many different diameters of these do I have to worry about?
Should I worry about getting another size right off?
What else should I look for to get it up and running.
A sine plate?
Spin indexer?
Rotary table?
Milwaukee Kearney Trecker Horizontal Vertical Milling Machine | eBay
Now to start tooling up.
Silly question time.
I think this is NMTB 50...Yes?
I figure a vise and a clamp set, perhaps an miteebite set too.
Parallels.
A long tool holder.
A short tool holder.
TG or ER collets? 100 or 150?
A shell mill holder...how many different sizes of those are there?
It has an arbor, how many different diameters of these do I have to worry about?
Should I worry about getting another size right off?
What else should I look for to get it up and running.
A sine plate?
Spin indexer?
Rotary table?