landm1
Cast Iron
- Joined
- Mar 19, 2008
- Location
- Paso Robles, CA
Hello,
We are making a .020" wide, .100" deep slot in 316 stainless. We have access to a nice 12,000 rpm spindle.
Any ideas for speeds and feeds? The end mill will have to be a bull nose, the bottom has radiuses on the sides and a slight flat bottom.
Type of end mill:
Speed:
Feed:
Depth of cut:
We probably have to do about 3" total, four of five slots, .7" each, so the tool has to hold up, we can feed down mostly in air.
We are making a .020" wide, .100" deep slot in 316 stainless. We have access to a nice 12,000 rpm spindle.
Any ideas for speeds and feeds? The end mill will have to be a bull nose, the bottom has radiuses on the sides and a slight flat bottom.
Type of end mill:
Speed:
Feed:
Depth of cut:
We probably have to do about 3" total, four of five slots, .7" each, so the tool has to hold up, we can feed down mostly in air.