Heinz R. Putz
Stainless
- Joined
- Mar 16, 2006
- Location
- Columbus, Ohio
This is about a Hurco CNC lathe, about 2 years old, I do not know the control model.
I am very familiar with most Fanuc, Yasnac, type programming, also with a few Centroid controls.
Its been many years since I touched a Hurco.
How close is todays Hurco G-Code programming to Fanuc?.
Also, is the setup similar?
Any advice is greatly appreciated, the machine is stuck on a truck from CA to here in Ohio, this great snow had something to do with it, but it will show up sooner or later and I would like to be as ready as I can.
If anyone has a short program, it would help greatly.
Heinz.
www.doccnc.com
I am very familiar with most Fanuc, Yasnac, type programming, also with a few Centroid controls.
Its been many years since I touched a Hurco.
How close is todays Hurco G-Code programming to Fanuc?.
Also, is the setup similar?
Any advice is greatly appreciated, the machine is stuck on a truck from CA to here in Ohio, this great snow had something to do with it, but it will show up sooner or later and I would like to be as ready as I can.
If anyone has a short program, it would help greatly.
Heinz.
www.doccnc.com