Adding a jog wheel to Tree 310 with Dynapath 10

Mechsoldier · Mar 8, 2015

I've been told this was an option, how do I tell in the controls if it's able to be enabled on my machine so I can pick one up and install it, right now I have the parameters set so my feed override also controls rapid over ride, and I have to just turn that down, then jog with the switch on rapid mode with the knob set to the ipm I want to feed. Kinda crappy.

Danny

Chip Chester · Mar 8, 2015

On our Dyanpath Delta 50, there's a screen at boot up, or in setup, that shows the list of enabled or installed options, which are highlighted within the list of all possible options. Yours may have a similar display.

Dynapath is still in business, and has an easy-to-find site. You might start there first, especially if making an error in parameters would leave you dead in the water, production-wise.

Chip

Search

Largest Manufacturing Technology Community on the Web

Search

Adding a jog wheel to Tree 310 with Dynapath 10

Mechsoldier

Plastic

Chip Chester

Diamond

Similar threads